TM 5-3820-233-12/1
d. Divide the circumference of the pulley into four
e. Start at center of pulley and apply short lengths of
equal sections and determine the necessary positioning
lagging toward both edges. Do not cover connecting
o flagging to be applied at an angle of the pulley surface
cracks of pulley.
Figure 4-45. Positioning lagging.
f. Use a hand roller and rubber mallet to remove
and roll or pound firmly from center of strip towards ends
air pockets or bubbles before adhesive has become
hardened. Apply roller pressure at center of each strip
Figure 4-46. Removing air pockets.
4-45