3208 INDUSTRAIL AND MARINE ENGINES
DISASSEMBLY AND ASSEMLBLY
REMOVE CAMSHAFT AND GEARS
11-1210 & 1212
Bolt 1/4"-20 NC x 1" long
Flat Washer 1/4"
remove timing gear cover and oil pump
remove valve lifters
Remove the plug from the fuel injection pump
housing and install timing pin (A).
While turning the crankshaft clockwise as seen
from the front of the engine, push on tool (A)
until it slides into the groove (slot) in the fuel
injection pump camshaft.
Install tooling (B) into the camshaft drive gear
for the fuel injection pump. Turn both bolts
evenly until the drive gear is free of the shaft.
Remove tooling (B).
Remove thrust pin (2) that holds the camshaft
in place from the rear of the cylinder block.
Remove the camshaft (3) and gears from the
cylinder block as a unit. Be careful not to
cause damage to the camshaft bearing or