Center the spring set in the parts so that they push
Position the housing on a solid surface with the port
down evenly and flush with the upper surface of the spool
face down. Start the spool assembly so that the splined
end of the spool enters the 14 hole end of the housing first.
and sleeve. Figure No. 32.
Figure No. 35.
Be extremely careful that the parts do not cock out of
position while entering. Push parts gently into place with
Install cross pin through spool assembly. Figure No.
slight rotating motion. Figure No. 36. Bring the spool
assembly entirely within the housing bore until the parts are
Push into place until cross pin is flush or slightly below at the meter end or 14 hole end of the housing. Do not pull
the spool assembly beyond this point to prevent the cross
the sleeve diameter at both ends. Figure No. 34.
pin from dropping into the discharge groove of the housing.
With the spool assembly in this flush position, check for
free rotation within the housing by turning with light finger
force at the splined end. Figure No. 37.