NOTES - CONTINUED:
for leaks, check crankcase oil level and bring to full
at high mark on dipstick. Hot engine, oil level must be
mark. When AOAP laboratory support is not available,
between high and low marks on dipstick (allow to set 5
install new filter element each 100 hours.
minutes before checking).
7. REAR WHEEL BEARINGS. Each 1000 hours, remove
5. ENGINE. Oil is to be changed each time an engine oil
wheels, clean and inspect all parts, replace worn or
change is directed by AOAP laboratory. When AOAP
damaged parts, repack bearings, and reassemble.
laboratory support is not available, change oil each 100
hours. Drain when oil is warm.
8. LUBRICANTS. The following Is a list of lubricants with
military symbols and applicable specification numbers.
6. ENGINE OIL FILTER. Filter is to be replaced each
time an engine oil change is directed by AOAP
OE/HDO
MIL-L-2104
laboratory. After In- stalling new filter element, fill
GAA
MIL-G-10924
crankcase, operate engine 5 minutes, check housing
OEA
MIL-L-46167
(SD), Type II
P-D-680
Copy of this Lubrication Order will remain with the
equipment at all times, instructions contained herein are
mandatory. By order of the Secretary of the Army:
JOHN A. WICKHAM, JR.
General, United States Army
Chief of Staff
OFFICIAL:
ROBERT M. JOYCE
Major General, United States Army
The Adjutant General
DISTRIBUTION:
To be distributed in accordance with DA Form 12-25B,
Operator and Organizational maintenance requirements
for Crushing and Screening Plants.
TA 220083
LO 5-3820-233-12-1
*U.S. GOVERNMENT PRINTING OFFICE: 1984-420-903/233
