TM 5-3820-233-12/1
APPENDIX C
BASIC ISSUE ITEMS LIST
Section I. INTRODUCTION
Code
Explanation
C-1. Scope
requisitioned, with accompanying justification, through normal
This appendix lists items which accompany the jaw
supply channels.
crusher or are required for installation, operation, or
G
Major assemblies that are procured with PEMA funds for initial
operator's maintenance.
issue only as exchange assemblies at DSU and GSU level.
These assemblies will not be stocked above GS and DS level
or returned to depot supply level.
C-2. General
This Basic Issue Items List is divided into the following
(2) Maintenance code, indicates the lowest category
sections:
of maintenance authorized to install the listed item. The
a. Basic Issue Items - Section II. A list of items which
maintenance level code is:
accompany the jaw crusher and are required by the
operator/crew for installation, operation, or maintenance.
Code
Explanation
b. Maintenance and Operating Supplies - Section III.
C
Operator/crew
A listing of maintenance and operating supplies required
(3) Recoverability code, indicates whether un-
for initial operation.
serviceable items should be returned for recovery or
salvage. Items not coded are expendable. Recoverability
C-3. Explanation of Columns
codes are:
The following provides an explanation of columns in the
tabular list of basic issue items, section III.
Code
Explanation
R
Repair parts (assemblies and components) which are considered
a. Source, Maintenance, and Recoverability Codes
economically reparable at direct and general support
(SMR).
maintenance levels. When the maintenance capability to repair
(1) Source code, indicates the source for the listed
these items does not exist, they are normally disposed of at
item. Source codes are:
the GS level. When supply considerations dictate, some of
these repair parts may be listed for automatic return to supply
for depot level repair as set forth in AR 710-50. When so listed,
Code
Explanation
they will be replaced by supply on an exchange basis.
S
Repair parts and assemblies which are economically reparable at
P
Repair parts which are stocked in or supplied from the GSA/DSA,
DSU and GSU activities and which normally are furnished by
or Army supply system and authorized for use at indicated
supply on an exchange basis. When items are determined by a
maintenance categories.
GSU to be uneconomically reparable they will be evacuated to
P2
Repair parts which are procured and stocked for insurance
a deport for evaluation and analysis before final disposition.
purposes because the combat or military essentiality of the
T
High dollar value recoverable repair parts which are subject to
end item dictates that a minimum quantity be available in the
special handling and are issued on an exchange basis. Such
supply system.
repair parts normally are repaired or overhauled at depot
M
Repair parts which are not procured or stocked, but are to be
maintenance activities.
manufactured in indicated maintenance levels.
U
Repair parts specifically selected for salvage by reclamation units
A
Assemblies which are not procured or stocked as such, but are
because of precious metal content, critical materials, or high
made up of two or more units. Such component units carry
dollar value reusable casings or castings.
individual stock numbers and descriptions are procured and
stocked separately and can be assembled to form the required
assembly at indicated maintenance categories.
b. Federal Stock Number. This column indicates the
X
Parts and assemblies which are not procured or stocked and the
Federal stock number assigned to the item and will be
morality of which normally is below that of the applicable end
used for requisitioning purposes.
item or component. The failure of such part or assembly
c. Description. This column indicates the Federal
should result in retirement of the end item from the supply
system.
item name and any additional description of the item
X1
Repair parts which are not procured or stocked. The requirement
required. The abbreviation "w/e", when used as a part of
for such items will be filled by use of the next higher assembly
the nomenclature, indicates the Federal stock number,
or component,
includes all armament, equipment, accessories, and
X2
Repair parts which are not stocked. The indicated maintenance
repair parts issued with the item. A part number or other
category requiring such repair parts will attempt to obtain them
through cannibalization. Where such repair parts are not
reference is followed by the applicable five-digit Federal
obtainable through cannibalization, requirements will be -
C-1
