CHAPTER 1
INTRODUCTION
Section I. GENERAL
Parts Lists or Supply Manual 7, 8, or 9) will be used for
1. Scope
reporting these improvements.
This form will be
a. These instructions are published for the use of
completed in triplicate using pencil, pen, or typewriter.
the personnel to whom the Roll Crusher, Eagle Model
The original and one copy will be forwarded direct to the
5230B is issued.
They provide information on
Commanding Officer, U. S. Army Mobility Support
organizational maintenance of the equipment, its
Center, ATTN:
SMOMS-MM, P.
O.
Box 119,
accessories, and auxiliaries. This manual also includes
Columbus, Ohio 43216. One information copy will be
instructions for shipment and limited storage.
provided to the individual's immediate supervisor (e.g.,
b. Appendix I contains a list of publications
officer, noncommissioned officer, supervisor, etc.).
applicable to this manual. Appendix II contains the
e. Report
all
equipment
improvement
maintenance allocation chart.
The organizational
recommendations as prescribed by TM 38-750.
maintenance repair parts and special tool lists are in TM
5-3820-205-20P/1.
2. Record and Report Forms
c. Numbers in parentheses on illustrations indicate
DA Form 2258 (Depreservation Guide of Engineer
quantity. Numbers preceding nomenclature callouts on
Equipment). For any other record and report forms
illustrations indicate the preferred maintenance
applicable to organizational maintenance, refer to TM
sequence.
38-750.
d. The direct reporting, by the individual user, of
Note. Applicable forms, excluding Standard Form 46
errors, omissions, and recommendations for improving
which is carried by the operator, will be kept in a canvas
this manual is authorized and encouraged. DA Form
bag mounted on the equipment.
2028 (Recommended Changes to Technical Manual
Section II. DESCRIPTION AND DATA
3. Description
(1) Starter
motor
identification
plate.
TM 5-3820-205-10/1 provides a general description
Provides make, model, serial number,
of the roll crusher. Specific and detailed descriptions of
and voltage of the starter motor. It is
the components of the lubrication and servicing unit are
mounted on the starter housing.
provided in the applicable maintenance paragraphs of
(2) Generator identification plate. Provides
this manual.
the make, model, serial number,
4. Identification and Tabulated Data
amperes, and voltage rating of the
a. Identification. Descriptions and locations of
generator. It is mounted on the generator
major identification plates on the roll crusher are listed
housing.
in TM 5-3820-205-10/1.
The machine has eight
(3) Generator Regulator Identification Plate.
identification plates on small, interchangeable
Provides the make, model, serial number,
components.
amperes, voltage, and type of ground. It
is located on the regulator housing.
AGO 8157A
3
