TM 5-3820-233-12/2
of 3300 pounds and remove elevating wheel assembly.
2-10. Elevating Wheel Assembly
b. Installation.
a. Removal.
(1) Remove the overhead conveyor belt (para
wheel assembly in the reverse procedure of removal.
(2) Install the under crusher and elevating wheel
(2) Remove the under crusher and elevating
drive guards.
(3) Install the overhead conveyor belt.
2-11. Walkway and Ladder
hopper, conveyor tail frame and elevating wheel as an
The crusher screening unit walkway, mounted on the left
assembly as follows:
(a) Disconnect drive shaft coupling from
side of the screen base, serves as a platform from which
the operator can control the sand and rock conveyors.
trunnion shaft.
a. Removal. Disconnect clutch controls and remove
(b) Disconnect elevating wheel from supports.
(c) Disconnect wiring harness.
b. Installation.
(d) Disconnect tail frame from intermediate
frame.
and ladder.
(e) Disconnect elevating wheel support
(2) Connect clutch control.
frame.
(f) Use a suitable lifting device with a capacity
2-14