TM 5-3820-233-35/1
Figure 32-2 (3)- Continued.
of seal up. Drive seal into housing until hole
lockwasher with groove in locknut and bend
in oil seal lines up with the tapped hole in
it over, seating it firmly with a drift punch.
housing. Tighten setscrew.
(o) Install bearing lockwasher (104
(d) Install side bearing grease flinger
as shown on figure 32-2 with beveled edge
127).
of flinger towards oil seal.
(e) Assemble
bearing
sleeve
and
bearing locknut. Refer to step n above to se-
cure locknut.
(f) Install bearing with sleeve and
(q) Install side bearing grease seal,
(g) Install bearing spacer seal (fig.
(r) Measure clearance between grease
32-13).
seal and bearing spacer. The clearance should
(h) Install side bearing as shown on
Note. All adjustable toggle seat was removed,
(i) Turn sleeve locknut by hand until
refer to step m (2 through 5), and install toggle seat
bearing and sleeve will stay in position.
before proceeding.
(j) Remove the sleeve locknut and in-
stall tightening nut (Special Tool-697-01)
pitman bearing and shaft assembly, with side
bearing assemblies, to the crusher base.
( k ) T u r n t h e t i g h t e n i n g n u t using
(4) Secure side bearing assemblies to
wrench (Special Tool-4550-751-09) in the
same manner as discussed for the removal nut
( s t e p f) .
(l) Turn the tightening nut until a
(6) Install toggle plate, and tension rod
0.003-0.005 inch clearance is measured be-
a n d s p r i n g ( s t e p s i a n d k) ,
tween the rollers and outer race of the bear-
32-3).
based on half the unmounted bearing clear-
(8) Install drive V-belts and make prop-
ance.
er belt tension adjustments (Operator's Man-
(m)
Install
sleeve
lockwasher
(106
ual).
and 130, fig. 32-2) and sleeve locknut (105
(9) Install guards (Operator's Manual).
and 129).
(10) Install walkway and railing (Opera-
sleeve locknut. line one of the prongs on the
tor's Manual).
4-19