TM 5-3820-233-35/1
STEP 1. DRAIN LUBRICANT FROM SIDE
BEARING HOUSINGS.
Figure 32-2 (1). Flywheel and pulleys, removal and installation.
bly, and lift toggle plate into crusher. Guide
i. Toggle Plate Reassembly
rounded edge of toggle plate into seat in pit-
(1) Install toggle seat (58, fig. 32-2) to
man toggle seat (58).
pitman. Toggle seat is held in position by a
(4) Slowly release hydraulic jack pres-
lug which fits into hole in pitman.
sure until pitman toggle seat mates with low-
(2) Install and position hydraulic jack
er rounded edge of toggle plate.
as shown on figure 32-5. Push pitman for-
(5) Remove the hydraulic jack.
ward with the hydraulic jack.
j. Key Plates and Jaws Reassembly. Refer
(3) Slide toggle plate (57) under the
to figure 32-4 and install the key plates, and
crusher. Attach a chain through hole in center
the movable stationary jaws.
of toggle plate which was done for disassem-
4-20
