DRIVE SHAFTS
DRIVE SHAFT DISASSEMBLY:
Dust Cover Kit
1.
To remove journal assembly, remove the
bearing retainer snap rings from the yoke.
3.
To remove yoke sleeve remove dust cap
and separate the shaft assembly.
2.
Press bearings from the yoke and remove
the journal assembly.
4.
When reassembling the unit, check for
proper yoke alignment if the drive shaft yoke sleeve has
been removed.
Journal Cross and Bearing
CENTER BEARING REMOVAL:
1.
Park machine on level ground, lower blade,
set parking brake and securely block machine.
2.
Remove front drive shaft assembly.
3.
Disconnect grease lines at center bearing.
4.
Remove retaining bolts and bearing.
5.
Reverse proceEdure.for installation.
Rev. 760501
50-1.3
K300