is not cocked and install four mounting plate cap screws.
Place the plate over this assembly so that the bolt
Tighten these evenly and gradually to a torque setting of
holes in the plate align with the tapped holes in the
250 inch pounds. Figure No. 43.
housing. Figure No. 46. Place the meter
Reposition in vise and clamp across the edges of the
gear ring on the assembly so that the bolt holes align.
mounting plate. Check to insure that the spool and sleeve
Figure No. 47.
are flush or slightly below the 14 hole surface of the control
housing. Figure No. 44.
Place the splined end of the drive within the meter
Clean the upper surface of the housing by wiping with
gear star so that the slot at the control end of the drive is in
the back of a clean hand or the butt of the thumb. Clean
alignment with the valleys between the meter gear teeth,
each of the flat surfaces of the meter section parts as It is
Figure No. 48. Push
ready for assembly in a similar way. Figure No. 45.
PAGE 14