TM 5-3820-233-12/1
wires. Replace if necessary.
4-32. Water Temperature Switch
(2) Inspect control rod for cracks or breaks.
a. General. The water temperature switch is located
(3) Replace all defective parts.
on the water manifold (fig. 4-18).
d. Installation. Install the shut down solenoid in order
b. Removal.
of removal (fig. 4-20).
(1) Disconnect electrical wiring.
(2) Remove water temperature switch.
c. Inspection. Inspect for frayed or cracked electrical
ing. Replace if necessary.
d. Installation. Install the water temperature switch in
reverse order of removal.
4-33. Overspeed Governor
a. General. The overspeed governor is located on
the power take-off end of the engine below the throttle
control (fig. 4-19).
b. Removal.
(1) Disconnect all electrical wiring.
(2) Remove 4 mounting bolts and remove
overspeed governor.
c. Inspection.
(1) Inspect for fraying or cracked wiring.
(2) Replace defective parts.
d. Installation. Install the overspeed governor in the
reverse order of removal.
4-34. Shut Down Solenoid
a. General. The shut down solenoid is located on
the right side of the engine below the fuel filter.
Figure 4-19. Overspeed governor, removal and
b. Removal. Refer to figure 4-20 and remove the
installation.
shut down solenoid.
c. Inspection.
(1) Inspect wiring harness for frayed or cracked
Figure 4-20. Shut down solenoid, removal and installation.
4-23
