(3) Connect the fuel lines to the fuel filters
(4) Disconnect the fuel lines from the fuel
(par, 63).
injectors (par. 61).
(4) Connect the fuel lines to the fuel primer
(5) Disconnect the fuel lines from the fuel
(par. 55).
injector pump as instructed on figure 22.
(5) Connect the fuel lines to the fuel tank
b. Cleaning, Inspection, and Repair. Clean and
(par. 64).
inspect all parts. Repair or replace damaged parts as
Caution
necessary.
If fuel connector screws (fig. 5) are
c. Installation.
loosened when connecting the line
(1) Connect the fuel lines to the fuel injector
assemblies, new washers must be
pump in reverse of the instructions on
installed and the screws torqued to
the proper tension of 420 inch-
(2) Connect the fuel lines to the fuel injectors
pounds. Overtorquing screws will
crush the copper gaskets allowing
the screws to bottom.
Figure 22. Fuel injector pump fuel lines, removal and installation.
AGO 8107A
41