Valves:
(12) Overspeed governor.
Intake (hot)......................... 0.020 in.
Manufacturer.............................Synchrostart Corp.
Exhaust (hot) ..................... 0.024 in.
Model .......................................GOM
Generator Regulator:
(13) Crankcase air cleaner.
Cut out relay air gap........... 0.048 in.
Manufacturer ............................Donaldson Co., The
Cut out relay point .............. 0.035 in. opening.
Type .........................................Oil bath
Cut out relay closing ........... 25-27 v (volts) voltage.
Current regulator ................ 0.115 in. air gap.
(14) Primer pump
Current regulator ................ 38 to 42 amp (amperes)
Manufacturer.............................Hartford Machine Screw
current setting.
Corp.
Voltage regulator ................ 0.084 in. air gap.
Model ........................................ 12383
Voltage regulator ................ 27.5 to 29.5 v
Type.......................................... Plunger
closing voltage ................ 28.5 v
(15) Electric motors.
(when adjusting
Manufacturer ............................General Electric Co.
set at middle of
Model .......................................5KG4256B2
range).
Horsepower ..............................10
(18) Nut and bolt torque data.
Cycles ....................................... 60
Intake manifolds ....................... 50-55 ft-lb (foot-pounds)
Rpm .......................................... 1,745
Voltage ....................................208-220/440
Fuel injectors............................ 14-16 ft-lb
Phase .......................................3
Fuel line connector ................... 420 in.-lb (inch-pounds)
Amperes ..................................27.4/13.7
screws.
Type .........................................KG
Wheel bearing adjusting .......... 50 ft-lb nut.
Time rating ...............................Continuous
Wheel bearing outer lock.......... 250-400 ft-lb nut.
(16) Tires.
Inner and outer wheel ............... 500-600 ft-lb nuts.
Type.......................................... LPT Nylon
(19) Electrical wiring diagram.
The wiring
Number of ply ........................... 20 ply rating
diagram for the jaw crusher is illustrated on figure 1.
Pressure ...................................100 psi (pounds per
square inch)
1 Serial No. range 2050 through 2087
Size .......................................... 11:00-15
Figure 1. Wiring diagram.
(Located in back of manual)
(17) Adjustment data.
Belts:
2 Serial No. range 2090 through 2129
Fan belt ............................. in. (inch) (es) deflection
Figure 1-Continued.
between pulleys on
(Located in back of manual)
long side.
Pan feeder apron ................ in. deflection assembly
motor belt.
3 Dolly wiring diagram
Scalper vibrating................. in. deflection screen
Figure 1-Continued.
assembly motor belt.
(Located in back of manual)
Discharge conveyor ............ in. deflection assembly
motor belt.
4 Trailer wiring diagram
Crusher assembly ..............1 to 1 in. deflection drive
Figure 1-Continued.
belts.
(Located in back of manual)
Moveable jaw ...........................1 in. to 5 in. between low
point in valley on one
5 Control and distribution panel, front view
jaw and high point of
Figure 1-Continued.
ridge on the other.
(Located in back of manual)
5.
Difference in Models
This manual covers the Eagle Model 5157 Jaw Crusher, serial No. ranges 2050 through 2087 and 2090 through
2129. Where differences exist between the two serial number ranges,
AGO 8156A
5
