reinspection, and replacement where
(6) If the injector assembly passes these
necessary.
tests, it can be installed in the engine. If
the injector assembly does not pass these
tests,
disassemble
for
cleaning,
c. Installation. Install the fuel injector assemblies
(TM 6-3820-205-20/2).
Section VIII. FUEL INJECTION PUMP AND GOVERNOR ASSEMBLY
64. General
65. Fuel Injection Pump and Governor Assembly
Removal and Disassembly
The fuel injection pump and governor assembly used
on this engine has a self-contained transfer pump which
a. Removal.
pumps fuel from the fuel filters to the working parts of
(1) Remove the fuel injection lines,
the injection pump. The fuel injection pump and
disconnect the throttle control cable, and
governor assembly contains an electric solenoid that is
electrical leads (TM 5-3820-206-20/2).
actuated by the electric governor.
This solenoid
(2) Refer to figure 16 and remove the fuel
regulates the fuel flow and speed of the engine.
injection pump and governor assembly
from the engine.
Figure 16. Fuel injection pump governor, drive shaft and drive gear assemblies, removal and installation.
AGO 845
42