Section V. HYDRAULIC CYLINDER ASSEMBLY
132.
General
134.
Hydraulic Cylinder Assembly Cleaning,
Inspection, and Repair
The hydraulic cylinder assembly is a five stage
Wash all parts in an approved
a. Cleaning.
telescopic cylinder which is used to raise and lower the
cleaning solvent, except the packing sets which should
pan feeder assembly from working position to
be wiped with a cloth dampened in an approved
transporting position.
cleaning solvent. Dry thoroughly.
133.
Hydraulic Cylinder Assembly Removal and
b. Inspection and Repair. Inspect for worn or
Disassembly
damaged parts. Replace or repair all damaged, worn, or
defective parts as necessary.
Remove the
hydraulic
cylinder
a. Removal.
assembly (TM 53820-205-20/2).
135.
Hydraulic Cylinder Assembly Reassembly
and Installation
Refer to figure
and
b. Disassembly.
disassemble the hydraulic cylinder assembly.
a. Reassembly. Refer to figure 40 and reassemble
the hydraulic cylinder assembly in the reverse order.
Note
Remove each internal tube, retaining
Note
ring, bearing, and snap ring as an
Install each snap ring, bearing, and
assembly and then remove the
retaining ring on its internal tube and
retaining ring, bearing, and snap ring
install the assembled internal tube.
from each internal tube.
Install the
hydraulic
cylinder
b. Installation.
assembly (TM 5-3820-205-20/2).
80