TM 5-3820-233-12/1
(2) Inspect rubber on wiper and make sure that
4-53. Belt Wiper
not part of the metal wiper contacts the belt.
All conveyor belts are equipped with belt wipers to
c. Installation. Refer to figure 4-43 and install the
remove crushed material that adheres to, or drops onto
conveyor belt wiper.
the back of the conveyor belt. These wipers prevent this
d. Adjustment.
material from passing over the pulley face.
(1) Loosen bolts holding rubber flashing to
a. Removal. Refer to figure 4-43 and remove the
clamp.
conveyor belt wiper.
(2) Move rubber strip down past the metal wiper
b. Inspection.
rubber makes slight contact with belt.
(1) Inspect flashing, if worn or damaged; replace
with new strips.
Figure 4-43. Belt wiper, removal and installation.
4-43
