TM 5-3820-233-12/1
sandpaper and brush off any particles of steel wool or
4-54. Conveyor Pulley Lagging
sandpaper dust remaining.
Pulley lagging may be applied with pulley intact on
c. Mix adhesive thoroughly and using a 3" brush,
conveyor or with pulley removed, as shown in
spread adhesive on in a smooth even layer. Cover 1/4 of
illustrations.
area from end to end and allow to become tack free (fig.
a. Remove dust and moisture with an approved b.
Remove all rust spots with coarse steel wool or
Figure 4-44. Applying adhesive.
4-44
