TM 5-3820-233-12/2
Figure 4-42. Skirtboard and flashing removal and installation.
with new strips.
4-53. Belt Wiper
(2) Inspect rubber on wiper and make sure that no
All conveyor belts are equipped with belt wipers to remove
part of the metal wiper contacts the belt.
crushed material that adheres to, or drops onto the back of
c. Installation. Refer to figure 4-43 and install the
the conveyor belt. These wipers prevent this material from
conveyor belt wiper.
passing over the pulley face.
d. Adjustment.
a. Removal. Refer to figure 4-43 and remove the
(1) Loosen bolts holding rubber flashing to clamp.
conveyor belt wiper.
b. Inspection.
(1) Inspect flashing, if worn or damaged replace
4-36
