TESTING AND ADJUSTMENT
ADJUSTMENT SCREW FOR FUEL FITTING
17 Adjustment screw, 1S. Locknut. 19, Lock nut.
19. stop pin.
ADJUSTMENT OP FUEL SETTING
e. Remove the test tools. Install cover (2) and shut-off
16. P2210locket, 20. screwdriver, 21.Wrenoh,
solenoid (1),
ADJUSTMENT OF CROSSOVER LEVERS
that hold levers (1 and 5), and make adjustment as
NOTE: The 3P1S46 Calibration Pin must be installed
necessary. Tighten screws (2 and 4) to 24 2 lb. in. (27.7
before checking the adjustment of the crossover levers.
2.3 cm. kg).
To check the adjustment of crossover levers (1 and 5),
NOTE: After the adjustment of the crossover levers is
put a straight edge across shafts (6 and 8). The dimension
completed, the fuel injection pumps must be calibrated.
(3) from the top of shafts (6 and 8) to the top of pin (7) is
See FUEL PUMP CALIBRATION.
.0828 in. (2.103 mm). To adjust, loosen screws (2 and 4)
CROSSOVER LEVERS
1. Crossover lever. 2. Screw. 3. Dimension for adjustment .0O28 in. 12.130 mm. 4. Screw. 5. Crossover
lever. 6. Shaft. 7. Pin. 8. Shaft.
60