parts. Replace all defective or damaged parts.
(1) Install the rubber mountings on the unit in
reverse of the instructions on figure 106.
c. Installation.
(2) Install the rubber deflectors on the unit in
reverse of the instructions on figure 107.
Section XI. WALKWAYS, LADDERS, AND PINTLE HOOK
171. General
173. Walkway Assemblies
The walkways are mounted on the crusher
frame and serve as platforms from which the operator
a. Removal.
services, inspects, and controls the crusher operation.
(1) Remove the ladders (para. 172).
The ladders give easy access from the ground to the
walkways and engine platform.
The pintle hook
(2) Remove the walkway assemblies from the
assembly is located on the rear of the trailer frame, The
unit as instructed on figure 109.
pintle hook is used for towing accessory units.
b. Cleaning acid Inspection: Clean and inspect all
172. Ladder Assemblies
parts. Replace all defective or damaged parts.
a. Removal. Remove the ladder assemblies from
c. Installation.
the unit as instructed on figure 108.
b. Cleaning and Inspection. Clean and inspect all
(1) Install the walkway assemblies on the unit
parts. Replace all defective or damaged parts.
in reverse of the instructions on figure
109.
c. Installation. Install the ladder assemblies on the
unit in reverse of the instructions on figure 108.
Figure 95. Roller stabilizer and bearing, removal and installation.
AGO 8157A
128