Figure 66. Air chamber assembly, exploded view.
Section II. FRONT AXLE, BOGIE AND REAR AXLE, AND WALKING BEAM ASSEMBLIES
b . I n s p e c t i o n a n d R e p a i r . Inspect all parts
234. General
f o r wear and damage. Replace or repair worn
T h e bogie and rear axle assembly supports
o r damaged parts.
the rear end of the roll crusher frame. It con-
sists of wheels, axles, service brakes, and walk-
237. Bogie and Rear Axles and Walking
ing beams. The front axle assembly is located
B e a m Assemblies Reassembly
under the dolly and fifth wheel assembly. It
a n d Installation
c o n s i s t s of wheels and axle and supports the
front of the crusher.
a. Reassembly.
235. Bogie and Rear Axles, and Walking
(1) Refer to figure 67, and reassemble the
B e a m Assemblies Removal
b o g i e , rear axles, and walking beam
and Disassembly
a s s e m b l i e s in the reverse order.
a . Removal. Remove the bogie and rear axle
( 2 ) I n s t a l l the service brake assemblies
a s s e m b l y (par. 36).
(par, 227).
b. Disassembly.
(3) I n s t a l l t h e a i r c h a m b e r a s s e m b l i e s
(TM 5-3820-205-20/1).
(1) Remove the air chamber assemblies
(TM 5-3820-205-20/1).
b. Installation. Install the bogie and rear
( 2 ) Remove the service brake assemblies
a x l e s assembly (par. 36).
(par. 226).
( 3 ) Refer to figure 67, and disassemble
238. Front Axle Assembly Removal
the bogie, rear axle, and walking
a. Remove the dolly assembly (TM 5-3820-
beam assembly.
205-10/1).
236. Bogie and Rear Axles, and Walking
b . Remove the front wheels and hub assem-
B e a m Assemblies Cleaning,
blies (TM 5-3820-205-20/1).
Inspection, and Repair
c. Remove the front axle in a similar manner
a. Cleaning. Clean all parts with an ap-
a s the rear axle (par. 235).
proved cleaning solvent and dry thoroughly.
AGO 8498A
