TM 5-3820-233-12/2
on the power take-off end of the engine below the throttle
4-32. Water Temperature Switch
a. General. The water temperature switch is located
b. Removal.
(1) Disconnect all electrical wiring.
b. Removal.
(2) Remove 4 mounting bolts and remove overspeed
(1) Disconect electrical wiring.
governor.
(2) Remove water temperature switch.
c. Inspection.
c. Inspection. Inspect for frayed or cracked electrical
(1) Inspect for fraying or cracked wiring.
wiring. Replace if necessary.
(2) Replace defective parts.
d. Installation. Install the water temperature switch in
d. Installation. Install the overspeed governor in the
reverse order of removal.
reverse order of removal.
4-33. Overspeed Governor
a. General. The overspeed governor is located
Figure 4-19. Overspeed governor, removal and installation.
(1) Inspect wiring harness for frayed or cracked
4-34. Shut Down Solenoid
wires. Replace if necessary.
a. General. The shut down solenoid is located on the
(2) Inspect control rod for cracks or breaks.
right side of the engine below the fuel filter.
(3) Replace all defective parts.
d. Installation. Install the shut down solenoid in reverse
down solenoid.
s. Inspection
4-19