b. Rear Panel Removal.
(1)
Remove the air cleaner (par. 63).
(2)
Remove the ether starting aids (par.
(3)
Remove the safety ignition switch
(4)
Remove the tachometer-hourmeter
(5)
Remove the indicator gages and
switches (pars. 87 through 89 and.
92).
(6)
Remove the battery charging
receptacle (par. 82).
(7)
Remove the rear panel from the
unit as instructed on figure 45.
c. Cleaning, Inspection, and Repair. Clean and
inspect.
Replace or repair worn, damaged, or
defective parts as necessary.
d. Hood, and Radiator Cowling Installation.
(1)
Install the hood and radiator cowling
on the unit in reverse of the
instructions on figure 45.
Figure 43. Drain lines, removal and installation.
(2)
Install the door supports and side
panels (par. 97).
c. Installation.
(3)
Install the muffler (fig. 7).
(1)
Install the engine side panels and
e. Rear Panel Installation.
door supports in reverse of
(1)
Install the rear panel on the unit in
instructions on figure 45.
reverse of the instructions on figure
(2)
Install the crankcase and water
45.
drain lines (par. 95).
(2)
Install the indicator gages (pars. 87
(3)
Install the engine doors (par.
through 89 and 92).
(3)
Install the tachometer-hourmeter
98. Hood, Radiator Cowling, and Rear Panel
(4)
Install the safety ignition switch
a. Hood, and Radiator Cowling Removal.
(5)
Install the ether starting aids (par.
(1)
Remove the muffler (fig. 7).
(2)
Remove the door supports and side
(6)
Install the air cleaner (par. 63).
panels (par. 97).
(3)
Remove the hood and radiator
cowling from the unit as instructed
on figure 45.
AGO 8156A
63